User Manual

© D Bird 2014 Page 9
"Sensor Test":
Displays the output from the sensors. See if all shows "OK". Move the
FC around and see that the numbers change.
"ACC Calibration":
Follow the instructions on the LCD to calibrate the Acceleration
Sensors, which is only necessary to do once at initial setup.
"CPPM Settings":
This menu allows different Transmitter manufacturers standards for
CPPM channels to be re-assigned, thus:
Roll (Ail): 1 to 2 (an example)
Pitch (Ele): 2 to 1 (an example)
Throttle: 3 to 4 (an example)
Yaw(Rud): 4 to 5 (an example)
AUX: 5 to 3 (an example)
This enables the Flight Control board to match any supplier’s standard.
PI Editor
Receiver Test
Mode Settings
Stick Scaling
Misc. Settings
Self-Level Settings
Camera Stab Settings
Sensor Test
ACC Calibration
CPPM Settings
Mixer Editor
Show Motor Layout
Load Motor Layout
Factory Reset
PI Editor
Receiver Test
Mode Settings
Stick Scaling
Misc. Settings
Self-Level Settings
Camera Stab Settings
Sensor Test
ACC Calibration
CPPM Settings
Mixer Editor
Show Motor Layout
Load Motor Layout
Factory Reset