T6A-V2 Instruction Manual

5.Battery charging notes
If you are using a nickel-cadmium, nickel-metal hydride batteries for
recharging, please use our company dedicated charger. If the electrical current
is too large and it may lead to temperature over-heated and cause fire burning
accident. Please cut off the power supply immediately after recharging. Please
take out the battery from the transmitter when you are not using it within a
period, it is because the battery may damage the aircraft batteries, thus being
exposed.。
Transmitter charger:
1. Install the battery to transmitter with correct direction, and cover it.
2. Connect the charger to the main connector.
3. Connect the charger to the transmitter
Connector.
4. Cut off the power supply immediately after
Recharge completed.
If your transmitter, receiver using a nickel-cadmium, nickel-metal hydride
rechargeable battery, you have to well-check before you fly. If lack of
electricity, it could happen those phenomenon like inadequate control or out of
control, resulting accident. So please charge immediately when low in battery.
Receiver charger:
1. Connect the charger to the main connector.
2. Connect the Rechargeable receiver with battery charger
3. Recharge completed, cut off the power supply immediately.
2. 4G 6 Channel remote system
4
Model: T6A-V2
Notes