T6A-V2 Instruction Manual

2. 4G 6 Channel remote system
15
Model: T6A-V2
Notes
Left click the 'ARF' button on the interface, the screen on the right
will appear, this function is use for the swash plate adjustment of
CCPM function helicopter, to have a better control.
CH1\CH2\CH4 are allowed to adjust Individual, Adjusted value from
0% to 100%. Number can be directly entered from the keyboard.
Click 'ok' button to finish the adjustment.
function is use for the programmable mixed control function, it offers
some special function.
This system offers three individual mixed control
function(MIX1/MIX2/MIX3)
Source: mixed control source select.
Des: destination select
Up rate: upper part's mixed control ratio (-100%to100%)
Down rate: lower part's mixed control ratio (-100%to100%)
Switch: Activation ways (OFF.ON.SWA.SWB)
Click 'ok' button to finish the adjustment.
Left click the 'SWITCH A' or 'SWITCH B' button on the interface, the
screen on the right will appear, this function is use for correspond
function select setting of switch A and switch B. following are the
choice of content:
NULL.DR.NORID.THRO.CUT.
Click 'ok' button to finish the adjustment.
Left click the 'VR (A)' or 'VR (B)' button on the interface, the screen
on the right will appear, this function is use for correspond function
select setting of both Potentiometers, following are the content
setting:
NULL.PITH ADJUST.
Click 'ok' button to finish the adjustment.
13.03 Switch and Potentiometers settings