User Manual

4. How to set ESC?
A. Press and hold SW1 until Green LED flash one time
，
and then release
，
Red
LED starts flashing
，
Enter [Battery Type] setup
。
[Number of Red LED Flashing
indicates current setting]
。
[ Battery Type ]
：
Nimh/Nicd * [ Red LED flashes one time ]
Lipo Auto Detect * * [ Red LED flashes two times ]
Quickly press SW1 to choose different setting, long press SW1 will store the
setting and exit the setup
B、Press and hold SW1 until Green LED Flashes two times，and then release，Red
LED starts flashing
，
Enter [ Operation Mode ] setup
。
[Number of Red LED
flashing indicates current setting]
[ Operation Mode ]:
Forward Only * [Red LED Flashes one time]
Forward with Reverse * * [Red LED flashes two times]
Quickly press SW1 to choose different setting, long press SW1 will store the
setting and exit the setup
C
、
Press and hold SWI until Green LED Flashes three times
，
and then release
，
Red
LED starts flashing，Enter [Initial Brake ] setup。[Number of Red LED flashing
indicates current setting]
[ Initial Brake ]:
10% * [Red LED Flashes one time]
20% * * [Red LED Flashes two times]
30% * * * [Red LED Flashes three times]
40% * * * * [Red LED Flashes four time]
50% ***** [RedLEDFlashesfivetimes]
60% ****** [RedLEDFlashessixtimes]
70% ******* [RedLEDFlashesseventimes]
80% ******** [RedLEDFlasheseighttimes]
Quickly press SW1 to choose different setting, long press SW1 will store the
setting and exit the setup
D
、
Press and hold SW1 until Green LED Flashes four times
，
and then release
，
Red LED starts flashing
，
Enter [ Rotation Reverse ] setup mode
。
[Number of
Red LED flashing indicates current setting]
[ Rotation Reverse ]:
Normal * [ Red LED Flashes one time]
Reverse * * [ Red LED Flashes two times]
Quickly press SW1 to choose different setting, long press SW1 will store the
setting and exit the setup
E
、
Press and hold SW1 until Green LED Flashes five times
，
and then release
，
Red LED starts flashing
，
Enter [ Default Settings ] setup mode
。
[Number of Red
LED flashing indicates current setting]
[ Default Settings]:
No * [ Red LED Flashes one time]
Yes * * [ Red LED Flashes two times]
Quickly press SW1 to choose different setting, long press SW1 will store the
setting and exit the setup