User Manual

Note: For proper ESC operation, please adjust transmitter as follows
Set High EPA or ATV to maximum setting; max throttle
Set Low EPA or ATV to maximum setting; max brake
Set throttle trim in the middle position
Set throttle Exponential to Zero.
Set Throttle mode F50/B50 for Practice Mode.
Set Throttle mode F70/B30 for Racing Mode.
Transmitter Calibration:
Press and hold the push button and then turn on ESC switch - Green LED on
Pull to Full Throttle
GreenLED flashing and then solid on.
Push to Full Brake
Red LED flashing and then solid on.
Neutral
Red & Green LED flashing, and then on,about 2sce All LED solid Off.
Switch Power off, then turn on again, the ESC be ready to work.
Normal Operation:
Green and Red LED on for Forward with pause then Reverse
Red on for Forward Only
As Battery voltage get to warning point, Red LED blink.
As temperature voltage get to warning point, Green LED blink.
Default Settings:
Battery Type - Auto Detec
Operation Mode - Forward with pause then Reverse
Initial Braking - 10%
Drag Brake - 0%
Motor Timing - Normal
Acceleration - Medium
Throttle Limit - 0%
Reverse Limit - 50%
Operating Frequency - 8KHz
Deadband - 4
Rotation Reverse - Normal

Summary of content (3 pages)