User Manual

Usually, low timing value is suitable for most motors. But there are many
differences among structures and parameters of different motors so please try and
select the most suitable timing value according to the motor you are just using. The
correct timing valuemakes the motor run smoothly. And generally, higher timing
value brings out higher output power and higher speed. Note3:After changing the
timing setting, please test your RC model on ground prior to flight!
Item 7. Governor Mode:*Off / Governor Low/ Governor High,
Value 1 is Off
Value 2 is Low
Value 3 is High
Default is Off
Item 8.Motor Type:*Normal Motor / Special Motor 1 / Special Motor 2,,
Value 1 is Normal Motor
Value 2 is Special Motor 1
Value 3 is Special Motor 2
Default is Normal Motor
Usually, the default value Normal Motor is suitable for most of motors,
but if the motor cannot run smoothly with this mode, please try other 2
options.
Item 9.PWM Frequency: *12KHz / 24KHz,
Value 1 is 12KHz
Value 2 is 24KHz
Default is 12KHz!±.
For some motors with high KV (high speed) and many poles, the 24KHz
PWM frequency may let them work more smoothly. But the higher PWM
frequency will make the ESC to be hotter.
Item 10.Built-In BEC Output: *5.25V / 6V,
Value 1 is 5.25V
Value 2 is 6V
Default is 5.25V.
Item 11.Motor Load:Normal / Heavy / Very Heavy / Auto.
Value 1 is Normal
Value 2 is Heavy
Value 3 is Very Heavy
Value 4 is Auto
For normal voltage ESC (supports 2-6 cells Lipo),
Default value is Normal