User Manual

TURNIGY Manual for Brushless Motor S~ed Controller
.llIlf.I~II:I.
Trouble
After power on, motor can't work, no
sound is emitted
After power on, motor can't work, such
an alert tone is emitted:
"beep-beep-, beep-beep-,beep-beep-"
(Every "beep-beep-" has a time interval
about
1 second)
After power on, motor can't work, such
an alert tone is emitted:
"beep-, beep-, beep- "(Every "beep-" has
a time interval about 2 seconds)
After power on, motor can't work, such a
alert tone is emitted:
"beep-, beep-, beep-" (Every "beep-" has
a time interval about 0.25 second)
After power on, motor can't work, a
special tone
")156712" is emitted after 2
beep tone (beep-beep-)
The motor runs in opposite direction
The motor stop running while in working
state
Possible Rea~on
The connection between battery
pack and ESC is not 01
Input voltage is
abnormal, too high
or too low
Throttle signal is
abnormal
I
I
Throttle stick is not in I
bottom( lowest) positi01
The direction of throttl~ channel is
reversed, so the ESC
~as entered
the program mode
The connection between ESC and
the motor need to be
chanqad.
Throttle signal is lost
ESC has entered
L~w Voltage
Protection mode
Some Connections are/not reliable
Action
Check the power connection.
Replace the connector.
Check the voltage of battery pack
Check the receiver and transmitter
Check the cable of throttle channel
Move the throttle stick to bottom
Set the direction of throttle channel correctly
Swap any two wire connections between ESC and
motor
Check the receiver and transmitter
Check the cable of throttle channel
Land RC model as soon as possible, and then
replace the battery pack
Check all the connections: battery pack connection,
throttle signal cable, motor connections, etc.
Move throttle stick to
bottom and then
switch on transmitter.
Connect battery
pack to ESC,
special tone like
"))123" means
power supply is OK
Several
"beel-" tones
should be mitted,
presenting th number
of lithium ba ery cells
When 'self-teet is
finished, a long
"beep-----"tone
should be emitted
Move throttle stick
upwards to go flying
_1111.1illllll (Throttle range should be reset when a n~w transmitter is being used)
Switch on
transmitter,
move throttle
stick to top
Connect battery
pack to ESC,
and wait for
about 2 seconds
"Beep-Beep-" tone
should be emitted,
means throttle range
highest point has been
correctlv confirmed
Move throttle stick to the
bottom, several "beep-" tones
should be emitted, presenting
the number of battery cells
A long "Beep-" tone should
be emitted, means throttle
range lowest point has
been correctly confirmed
- 3-