Installation Guide
1 - With a cloth, remove all the wall dust.
2 - Our Mouldings need to be cutting
quickly and accurately. Make the necessary
cut, according to the cut method of this
manual.
3 - With the aid of a cloth, remove all
waste from the bar.
4 - Apply small pieces of approximately
1 ½" with spacing between the tapes of
maximum 15".
Note: For a better setting, use double-
sided tape with a minimum width of ½".
Before beginning the installation, analyze the wall type to
choose the best installation method.
5 - Aer double-sided tape application,
take the glue and apply behind the
profiles, making two lines parallel o the
groove on the moulding.
Note: 3 lines of glue parallel to the
groove are recommended for profiles
higher than 4 inches (with a height
greater than 4 inches).
6 - Now place the profile in the
installation position and press against
the wall. For a better result, use your
hand or a rubber hammer.
7 - Use super glue at the profile's joints.
8 - Make the finishing, according to the
FINISHING METHOD of this manual.
INSTALLATION METHOD
GLUE AND DOUBLE-SIDED TAPE
15"
MAXIMUM
SPACING
Figure 01 - maximum space between tapes.
RECOMMENDED MINIMUM SIZE
1 ½"
½"
Figure 02 - Minimum size recommended for double-sided tape.
1
4
3
6
8
2
5
7