Installation Guide

TOP FINISHING
Before starting all cuts, place profiles’ edges at a 90º angle.
1 - Make a 45º angle cut with the
baseboard in the horizontal position.
Keep the small piece le, this piece must
have one side cut at a 45º angle and the
other side at a 90º angle, it’s this piece
that will make the “top finishing”. Turn
the profile and cut the other side also
at a 45º angle, starting by the main face.
Note: The cut distance must be equal to
the profile thickness.
2 - Apply moisture resistant super glue,
to the two cut pieces in angle (small
piece and bar).
3 - Connect the two cut pieces in angle
with super glue.
1
2
3
SEAMS IN PROFILES’ MERGER
90º DEGREES SEAMS FOR WALL CORNERS
1 - When starting to install Santa Luzia
Mouldings on wide walls, you may need
to combine multiple profiles. For that,
cut the profiles’ edges in 45º angle.
2 - Connect the profiles in a way one cut
completely covers the other.
1 - Cut the merging profiles in 45º angle,
starting with the main face.
2 - One of the profiles need to be cut
backwards for joining with the other.
Aer performing the cuts, place the
profiles together on the wall corner to
make sure the angle is closed. Aer that,
set the profiles.
CUTTING METHODS FOR
SANTA LUZIA PRODUCTS
1
1
2
2