Product Manual

Trimming is easy, you may
either use the trim
nozzle, or the standard
hydro seeding nozzle.
Close the gun valve
about half way. When
working close to houses
or other objects the
closer you hold the gun
to the ground, the less
distance any splatter
will travel. Any
splatter that goes on to
houses, sidewalks, brick,
etc, will NOT stain. It
may either be washed off
or will disappear on its
own in a week or two.
LAWN REPAIR AND
RENOVATION
Turbo Turf Hydro
Seeding Systems are ideal
for over seeding, and for
repairing lawns damaged
from summer heat,
traffic and pets. It can
be done quickly and
easily with your unit.
Unless there is a heavy
build up of thatch very
little preparation is
required. To over seed,
simply mix a load as
usual, except use about ¾
or 1/2 of the normal
amount of mulch. Use the
standard hydro seeding
nozzle and point the gun
straight down. To repair
areas that are dead, use
the trim nozzle, and you
will be able to follow
the contours of the dead
spots precisely. You may
need to use a liquid or
water soluble
fertilizer.
MAINTENANCE &
CLEANUP
If you are doing more
than one job in a day, it is
usually not necessary
to clean out the unit
between jobs. At the end
of each day we
recommend that the unit
be cleaned out. The
procedure is simple. Just
put at least 50 gallons of
water in the unit (25
gallons for 50, 100, and 150
gallon units). Start the
engine, open the
agitation valve for 10
seconds, close the
agitation valve totally
and spray out
everything in the tank
Engine
Maintenance and
Operation
********IMPORTANT*
*******
In addition adhering to
the recommended
maintenance procedures
in your engine
manufacturer’s Owner’s
Manual, we strongly
recommend you to read
the following:
Because your engine is
coupled directly to an
impeller style pump, the
engine is under load 100%
of the time it is
operating. It is
necessary to always run
your engine at ½
throttle or higher at
all times. The cooling
fan in your engine is
designed to be effective
at above ½ throttle.
Running your engine at
idle while under load
does not provide enough
12