Manual

8 TLX84 and TLX215L Rigging Manual
2.2 Rigging and Acoustic Simulation Software
The EASE FOCUS II software allows you to congure the system for optimal performance and coverage in the venue.
The software can be downloaded from http://www.afmg.eu/index.php/products.html
The quantity of cabinets can be varied, the angles of each cabinet can be adjusted, and the SPL coverage calculated for any conguration.
Once an optimum system has been designed using the EASE FOCUS II software, the angles of each TLX84 cabinet should be noted, as well as the correct suspension
hole on the TLX84-FLB ybar, where your bow shackle would be tted for single-point suspension. For two-point suspension, pick point holes #1 and #10 can be
utilized in conjunction with front and rear chain motors to obtain the desired array site angle.
The EASE FOCUS II screenshot below is for a typical TLX84 conguration. Check the "RIGGING" Tab and and note installation parameters such as: array weight,
bottom element elevation above ground level, bottom enclosure angle.
Note the angle of each TLX84 cabinet in the "Object Properties" Tab.
 WARNING
ERROR AND WARNING INDICATIONS ARE GIVEN IN THE OBJECT PROPERTIES
WINDOW IF WORKING LOAD LIMITS ARE EXCEEDED AT 10:1, 7:1 OR 5:1 DESIGN
FACTORS. HEED THESE WARNINGS AT ALL TIMES IN ACCORDANCE WITH
LOCAL REGULATIONS.
EASE FOCUS II Typical Screenshot for a TLX84 Array
Rigging Tab Shows the layout graphically,
and indicates the correct suspension pick point to
choose on the ybar.
TLX84 Cabinet Angles