Manual

Table Of Contents

TLX84 and TLX215L Rigging Manual 33

Procedure 6.1 - Assembling the two TLX215L Subwoofers

1. Prior to stacking, ensure that all mount hardware on upper and lower

subwoofers are their stored positions. Carefully lower and physically align

top and bottom subwoofers so that front lower mounting links (3) and the

rear drop link (5) of the top subwoofer will properly align with the mount

link slots (6) and the rear drop link channel of the lower subwoofer.

2. Pull out the lower subwoofer's upper front pins (7) then remove the lower

front rigging pins (2) of the top subwoofer. Allow front mounting links (3)

to slide downwards from the top subwoofer into the bottom subwoofer’s

mount link slots (6). Secure the mounting links to the upper subwoofer with

pins (2) and to the lower subwoofer with pins (7).

3. Remove the rear pin (4) and the rear drop-down link (5) will drop down.

Check that the drop down link (5) and its pivot pin and circlip and are all

present, clean, and in good condition. Check that the circlip is correctly

holding the pivot pin in place, and preventing it and the drop down link from

falling out.

Take care not to trap your ngers between components.

4. Align the top subwoofer's drop-down link (5) with the hole (8) in the

lower subwoofer's rear bracket. Insert the rear pin (4) to secure the

subwoofers together.

Double check all the connections to make sure that the

TLX215L subwoofers are securely connected together.

 WARNING

DO NOT EXCEED A TOTAL QUANTITY OF 3 TLX215L SUBWOOFERS FOR THIS

GROUNDSTACK CONFIGURATION. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE

PERMANENT INJURY OR DEATH.

 CAUTION

DO NOT LOWER THE TLX215L SUBWOOFER ONTO THE GROUND WITH THE

MOUNTING LINKS (3) AND DROP-DOWN LINK (5) IN THE DOWN POSITION.

THIS MAY CAUSE DAMAGE TO THE LINKS AND THE DROP-DOWN LINK, OR CAUSE

DAMAGE TO THE STAGE. THEY SHOULD BE RETRACTED BY REVERSING THE ORDER

OF THE STEPS ABOVE.

NOTE

Disassembly is the reverse of assembly.