Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX84 Array on a TLX84-FLB Flybar
- Chapter 4: Assembling TLX215L Subwoofers on a TLX84-FLB Flybar
- Chapter 5: Assembling a TLX84 Array with a TLX215L Subwoofer
- Chapter 6: Groundstack of two TLX215L Subwoofers
- Chapter 7: Groundstack TLX215L Subwoofer and TLX84 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure quantities and combinations for TLX84-FLB flybar suspension at 10:1, 7:1, 5:1 design factors
- Manufacturer’s Declaration
30 TLX84 and TLX215L Rigging Manual
Procedure 5.2 - Attaching the TLX84 Cabinets to the TLX215L Subwoofer
1. Pull out the front rigging pins (7) of the rst TLX84 cabinet. Carefully lower
the upper ybar and subwoofer assembly using your lifting apparatus and
align the subwoofer's front links (3) with the top mounting slots (6) of the
TLX84 cabinet. Insert the front pins (7) to secure the front links (3).)
Take care not to trap your ngers between components.
2. Support the rear of the TLX84 cabinet and align the subwoofer's drop-
down link (5) with the desired hole (8) in the TLX84 rear drop link channel.
The holes are marked with the angle from 0 to 6 degrees. Choose the
correct hole that corresponds to the angle recommended by EASE FOCUS II
software for the rst TLX84 cabinet. Insert the rear pin (9) to secure the link
to the cabinet.
Double check that all pins are correctly inserted,
before proceeding further.
3. Add further TLX84 cabinets below the rst TLX84 cabinet, in a similar way,
up to a maximum of 4 cabinets.
4. Alternatively, a previously-assembled group of four TLX84 cabinets can be
assembled to the bottom of the TLX215L subwoofer.
3
7
6
9
8
5