Manual

TLX84 and TLX215L Rigging Manual 21
Chapter 3: Assembling a TLX84 Array on a TLX84-FLB Flybar
3.0.1 Required Components
Item Quantity
TLX84-FLB Flybar 1
TLX84 Cabinet 8 (maximum)
3.0.2 Preparation
Use the EASE FOCUS II software application to design your system to suit the
venue. This will calculate which ybar mounting hole to attach your bow shackle,
and at which angle to set each TLX84 cabinet to achieve optimum coverage.
3.0.3 Location
Move the rst TLX84 cabinet so it is sitting upright on a safe at surface,
directly below the suspension point.
3.0.4 Measured Weights
Item Quantity Total Weight including one TLX84-FLB Flybar
TLX84 1 53.0 kg 117 lbs
2 80.9 kg 178 lbs
3 109 kg 240 lbs
4 137 kg 301 lbs
5 165 kg 363 lbs
6 193 kg 424 lbs
7 220 kg 486 lbs
8 248 kg 547 lbs
TLX84-FLB Flybar Working Load Limit (WLL)
Item Working Load Limit (WLL)
TLX84-FLB 260 kg 573 lbs
The following procedure shows how to build an array of TLX84 cabinets by
adding them one at a time.
Alternatively, cabinets can be pre-assembled into groups of four, and then
connected to the ybar at a later time. This method is shown in procedure 3.2.
The system is suspended using a TLX84-FLB ybar that attaches to your
lifting system.
The top TLX84 cabinet connects to two front links on the ybar, and one rear
drop-down link.
There are 7 rear mounting holes on the back of the TLX84 that allow the cabinet
angle to be selected from 0 to 6 degrees.
 WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 8 TLX84 CABINETS FOR ONE TLX84-FLB
FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT INJURY
OR DEATH.
3.0.5 Personnel
The following procedures shall be undertaken by experienced, certied,
qualied, and authorised personnel only. The procedures require the use of three
or more authorised persons.
Protective Headwear shall be worn
Protective Footwear shall be worn
Protective Gloves shall be worn
Protective Eyewear shall be worn
Practice Safe Lifting