Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
46 TLX43 and TLX212L Rigging Manual
Chapter 8: Safety Inspection
The following notes must be read and followed before suspending the systems or ground stacking:
Cabinets
Inspect all cabinets carefully and make sure that all surfaces are clean, in good condition, and free from cracks, corrosion, or any other defects that may weaken the
assembly. Check for any missing screws, rigging pins, mounting links, or drop down links, pivot pins, or their circlips.
All cabinets must be clean and dry, and free from any debris that might cause incorrect or faulty operation.
Check that all mounting holes are clean and in good condition, and will accept the rigging pins correctly.
Flybar
Inspect the ybar carefully and make sure it is in good condition and free from cracks, corrosion, or any other defects that may weaken the assembly. Check for any
missing rigging pins, or drop down links.
Check that all mounting holes are clean and in good condition, and will accept the rigging pins correctly.
Rigging Pins
Inspect all rigging pins carefully and make sure they are in good condition and free from cracks, corrosion, or any other defects that may weaken them.
Check that the retaining ball bearings are present and operate correctly.
Check that all rigging pins and connecting drop down links are correctly and fully inserted.
Drop Down Links
Inspect all drop down links and their pivot pins and circlips carefully and make sure they are in good condition and free from cracks, corrosion, or any other defects that
may weaken them.
Check that the retaining pivot pins are present and operate correctly to retain the drop down links.
Check that all circlips are present, installed correctly, and retain the pivot pins correctly.
Care and Maintenance
In addition to regular inspections, make sure that all equipment is kept clean and dry by careful brushing and wiping down with a cloth. Light use of lubrication such
as WD40 may be applied to the rigging pins and mounting holes.
All equipment must be stored in a clean and dry state to prevent corrosion.
Transportation
Use only recommended road cases to transport the loudspeakers and components.
Regularly Scheduled Inspections
In addition to the visual inspection of all rigging components, regular, more rigorous test and inspection of rigging components must also be carried out.
Safety legislation and test and inspection requirements will vary from country to country. In most cases, semi-annual or annual independent test and inspection by a
suitably approved and qualied inspector will be required. Users must ensure compliance with all applicable safety requirements. TURBOSOUND recommends regular
safety inspections, and further recommends that a logbook be kept detailing the test and inspection history of each TURBOSOUND rigging accessory. Always wear
protective head-wear, footwear and eye protection in accordance with local regulations. Anyone involved in suspending ANY sound system should take note of the
following advice:
The rigging of a suspended sound system may be dangerous unless undertaken by qualied personnel with the required experience and certication to perform the
necessary tasks. Fixing of hanging points in a roof should always be carried out by a professional rigger and in accordance with the local rules of the venue.
The house rigger and/or building manager must always be consulted.