Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
TLX43 and TLX212L Rigging Manual 43
5. Align the ybar's link (9) with the desired hole (5) in the TLX43 rear bracket.
The holes are marked with the angle.
6. Insert the rear pin (6) to secure the ybar link (9) to the TLX43 cabinet.
Double check all pins are correctly inserted, before
proceeding further.
7. Prepare the second TLX43 cabinet, by pulling out the front two pins (3)
from the top mounting lugs (4), and remove the rear pin (6) from the
rear mounting hole (5). The rear drop-down link (7) of the cabinet will
drop down.
8. Turn the TLX43 cabinet upside-down.
9. Lift this TLX43 cabinet until the front two mounting lugs (4) align with the
two mounting lugs (10) of the TLX43 cabinet below it.