Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
42 TLX43 and TLX212L Rigging Manual
Procedure 7.2 - Attaching the TLX43 Cabinets to the TLX43-FLB Flybar
1. Prepare the rst TLX43 cabinet, by pulling out the front two pins (3)
from the top mounting lugs (4), and remove the rear pin (6) from the
rear mounting hole (5). The rear drop-down link (7) of the cabinet will
drop down.
2. Turn the TLX43 cabinet upside-down.
3. Carefully lift the TLX43 cabinet onto the TLX43-FLB ybar on top of
subwoofer, and align the front mounting lugs (9) of the ybar with the two
mounting lugs (4) of the TLX43 cabinet.
Take care not to trap your ngers between components.
4. Insert the front two pins (3) to secure the front mounting lugs (9) of the
ybar with the two top mounting lugs (4) of the TLX43 cabinet. Support the
rear of the cabinet until the ybar's rear link is connected in the next step.