Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
TLX43 and TLX212L Rigging Manual 39
Procedure 6.1 - Assembling the two TLX212L Subwoofers
1. Make sure the bottom subwoofer is on a at, horizontal, and steady surface.
2. Carefully lower the top subwoofer on top of the bottom subwoofer and allow
the stacking runners on the bottom of the upper enclosure to self-center
with the stacking recesses on the top of the lower enclosure.
Take care not to trap your ngers between components.
3. Remove the front rigging pins on both sides of the lower TLX212L subwoofer.
Remove rigging pins on the front drop links of the upper TLX212L subwoofer
and lower the drop links into position between upper and lower subwoofers.
4. Secure front drop links using two rigging pins (1) on upper and lower
TLX212L subwoofers on both sides (4 rigging pins total).
5. Remove the rigging pin on the rear drop link of the upper TLX212L
subwoofer and rotate the drop link into position between upper and lower
subwoofers.
6. Insert the rear pin (6) to secure the drop down link (4) of the top subwoofer
into the mounting hole (5) of the bottom subwoofer.
1
4
5
6
1