Manual

TLX43 and TLX212L Rigging Manual 33
Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
5.0.1 Required Components
Item Quantity
TLX43-FLB Flybar 2
TLX212L Subwoofer 1 (maximum)
TLX43 Cabinet 4 (maximum)
5.0.2 Measured Weights
Total Measured System Weight
Item Quantity
Total Weight including two TLX43-FLB Flybars
and one TLX212L Subwoofer
TLX43 1 64.6 kg 142 lbs
2 72.6 kg 160 lbs
3 80.6 kg 178 lbs
4 88.6 kg 195 lbs
TLX43-FLB Flybar Working Load Limit (WLL)
ng Load (SWL)
Item Working Load Limit (WLL)
TLX43-FLB 94 kg 207.23 lbs
The following procedure describes how to assemble a mixed array consisting of
one TLX212L subwoofer and four TLX43 cabinets below it.
One TLX43-FLB ybar is attached to the top of the TLX212L subwoofer,
using components supplied with the TLX43-FLB ybar.
A second TLX43-FLB ybar is attached to the bottom of the TLX212L subwoofer,
using 2 front pins supplied with the ybar, and a rear drop-down link of
the subwoofer
An array of up to a maximum of four TLX43 cabinets is suspended from the lower
TLX43-FLB ybar.
 WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 1 TLX212L SUBWOOFER AND 4 TLX43
CABINETS FOR THIS CONFIGURATION. FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE PERMANENT INJURY OR DEATH.
 WARNING
THIS ARRAY SHALL ONLY BE MADE WITH THE TLX212L SUBWOOFER ON TOP,
AND THE TLX43 CABINETS BELOW. FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE PERMANENT INJURY OR DEATH.
5.0.3 Personnel
The following procedures shall be undertaken by experienced, certied,
qualied, and authorised personnel only. The procedures require the use of three
or more authorised persons.
Protective Headwear shall be worn
Protective Footwear shall be worn
Protective Gloves shall be worn
Protective Eyewear shall be worn
Practice Safe Lifting