Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
TLX43 and TLX212L Rigging Manual 31
Procedure 4.4 - Connecting a Second TLX212L Subwoofer
8
9
10
8
9
10
1
4
3
1. Attach a bow shackle or other lifting equipment securely to the correct
ybar pick point hole as recommended by EASE FOCUS II software, then
attach the hook and chain to the bow shackle.
2. Carefully raise the ybar/subwoofer to provide sucient clearance for
adding a second subwoofer, in preparation for the next steps.
3. Move the bottom TLX212L subwoofer to a position directly below the top
subwoofer. Make sure it is resting on a at steady surface.
4. Carefully lower the rst subwoofer down on top of the second subwoofer,
and allow the stacking runners on the bottom of the upper enclosure to
self-center with the stacking recesses on the top of the lower enclosure.
Take care not to trap your ngers between components.
5. Lower front drop links; pin to upper enclosure; pin to lower enclosure
6. Lower rear drop link; pin to lower enclosure