Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
28 TLX43 and TLX212L Rigging Manual
Procedure 4.1 - Installing the TLX212L Subwoofer Top Mounting Links
The TLX43-FLB ybar is supplied with two sub links (1) that are installed in the
top of the TLX212L subwoofer. These form the mounting points for connecting
the ybar to the subwoofer.
1. Remove the upper-front pin (3) of the subwoofer.
2. Lower the mounting link (1) into the slot on top of the subwoofer, until the
middle hole of the link lines up with the hole of the pin (3).
3. Insert the pin (3) to capture the center hole of the mounting link (1).
Check all links, and pins are securely connected to
the subwoofer.
NOTE
Disassembly is the reverse of assembly.