Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
TLX43 and TLX212L Rigging Manual 25
Procedure 3.2: Adding a group of four TLX43 Cabinets to the TLX43-FLB Flybar
Groups of four cabinets can be pre-assembled using Procedure 3.1, steps 7
through 10, and then connected to the TLX43-FLB ybar as an assembled group
of four just prior to ying.
The TLX43 cabinets connect to each other using the top and bottom front
mounting links, and the rear drop-down link.
1. Prepare the top TLX43 cabinet of the group of four, by pulling out the front
two pins (3) from the top mounting lugs (4).
2. Carefully lower the TLX43-FLB ybar onto the top TLX43 cabinet and align
the front mounting lugs (8) of the ybar with the two top mounting lugs (4)
of the cabinet.
WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 4 TLX43 CABINETS FOR EACH
PRE-ASSEMBLED GROUP. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE
PERMANENT INJURY OR DEATH.
WARNING
DO NOT FLY THE PRE-ASSEMBLED GROUPS OF TLX43 CABINETS WITHOUT THE
TLX43-FLB FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT
INJURY OR DEATH.
3
4
8
9
5
4 4 3 6