Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
24 TLX43 and TLX212L Rigging Manual
Procedure 3.1 continued
9. Insert the front two pins (1), to secure the front top mounting lugs (2) of this
TLX43 cabinet to the two bottom mounting lugs (8) of the TLX43 cabinet
above it.
CAUTION:
Support the rear of the cabinet until the rear drop-down link (5) is connected
(next step).
Take care not to trap your ngers between components.
10. Align the rear drop-down link (5) of the top TLX43 cabinet with the desired
mounting hole (3) in the rear of the TLX43 cabinet below it. The holes are
marked with the angle. Choose the correct hole that corresponds to the
angle recommended by EASE FOCUS II software for this TLX43 cabinet.
Insert the rear pin (4).
Double check that all pins are correctly inserted, before
proceeding further.
11. The addition of other TLX43 cabinets is performed by repeating steps 7
through 10 for each additional cabinet.
WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 10 TLX43 CABINETS FOR ONE TLX43-FLB
FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT INJURY
OR DEATH.
NOTE
Disassembly is the reverse of assembly.
1
1
5
3
4
1st
2nd