Manual

TLX43 and TLX212L Rigging Manual 23
5. Align the ybar's drop-down link (7) with the desired hole (3) in the TLX43
rear bracket. The holes are marked with the angle. Choose the correct hole
that corresponds to the angle recommended by EASE FOCUS II software for
the rst TLX43 cabinet. Insert the rear pin (4).
No te: normally the 0 degree hole is selected to attach the top TLX43
enclosure to the TLX43-FLB in order to set the site angle of the top element
parallel to the ybar. This allows the TLX43-FLB to serve as a visual reference
for checking array focus on the audience area, i.e., if you can see the
top of the TLX43-FLB then you are outside the vertical coverage pattern
of the array.
Double check that all pins are correctly inserted,
before proceeding further.
6. Attach the bow shackle or other lifting equipment securely to the ybar
mounting hole recommended by the EASE FOCUS II software, then attach
the hook and chain. Carefully raise the ybar to a reasonable working height
to allow attaching the next cabinet.
7. Prepare the next TLX43 cabinet, by pulling out the front two pins
(1) from the top mounting lugs (2), and remove the rear pin (4) from
the rear mounting holes (3). The rear drop-down link (5) of the cabinet
will drop down.
 CAUTION
Check that the drop down link (5) and its pivot pin and circlip and are all present,
clean, and in good condition. Check that the circlip is correctly holding the pivot
pin in place, and preventing it and the drop down link from falling out.
8. Lift this TLX43 cabinet until the front top mounting lugs (2) align with the
two bottom mounting lugs (8) of the TLX43 cabinet above it.
2
8
7
4
3
1 1 43
5
8
2 2
1st
2nd
2nd
Degrees
0
2.5
5.0
7.5