Manual

22 TLX43 and TLX212L Rigging Manual
1. The TLX43-FLB ybar comes with extra components (marked* in this
drawing) that are only used when rigging the TLX212L subwoofer.
Remove these components from the ybar and keep them together in a
safe place.
2. Prepare the rst TLX43 cabinet, by pulling out the front two pins (1)
from the top mounting lugs (2), and remove the rear pin (4) from the rear
mounting holes (3). The rear drop-down link (5) of the cabinet will
drop down.
3. Remove the small rigging pin from its storage position on the ybar and
allow the ybar's captive rear drop link to drop down. Re-insert the rigging
pin in its storage location on the TLX43-FLB.
Carefully lower the TLX43-FLB ybar on top of the rst TLX43 cabinet and
align the ybar’s mounting lugs (6) with the two top mounting lugs (2)
of the cabinet.
4. Insert the front two pins (1) to secure the front mounting lugs of the ybar
(6) with the two top mounting lugs (2) of the TLX43 cabinet.
 CAUTION:
Support the rear of the ybar until the rear drop-down link (7) of the ybar is
connected in the next step.
Take care not to trap your ngers between components.
*
*
1 1 43
5
2 2
6
1
1
1st
Procedure 3.1 Connecting TLX43 Cabinets to the TLX43-FLB Flybar