Manual

TLX43 and TLX212L Rigging Manual 19
2.14 TLX43-FLB Flybar Mounting Components
3
2
1
1
Typical Bow Shackle
The TLX43-FLB ybar shall only be used with TLX43 cabinets and TLX212L
subwoofers. One side is used to connect to a TLX43 cabinet, the other side is used
to connect to the top (or bottom) of a TLX212L subwoofer.
2.14.1 Use with TLX43 Cabinet
1. Mounting Lugs – These connect the ybar to the top lugs of the
TLX43 cabinet. The connections are secured using the front pins of the
TLX43 cabinet.
2. Drop-Down Link – This connects the ybar to the rear mounting point of
the TLX43 cabinet. It has a xed pivot and circlip. The connection is secured
using the rear pin of the TLX43 cabinet.
3. Suspension Points – These 20 mm diameter holes are used to attach
a bow shackle or similar lifting equipment for suspending the assembly.
Use the EASE FOCUS II software to determine the correct pick point for each
conguration.
Suspend the array by attaching one or more bow shackles or similar lifting
devices with a pin diameter (D) to t the 20 mm suspension pick point.
Typically, manufacturers of bow shackles provide suitable devices with
pin diameters between 11 mm and 19 mm, and with work loads between
1 tonnes and 3.25 tonnes.
Installation and setup should only be carried out by qualied and authorized
personnel observing the valid national Rules for the Prevention of Accidents
(RPA). Refer to Chapter 1 for more details.
NOTE
The TLX43-FLB ybar is supplied with hardware for use with a TLX212L
subwoofer. See the next page for more details. The hardware can be removed
and kept in a safe place if a TLX212L subwoofer is not used.