Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
TLX43 and TLX212L Rigging Manual 17
2.12 TLX212L Subwoofer
Mounting Components
Mounting Links Out
Mounting Links In
The TLX212L subwoofer has two retractable mounting links at the bottom (6),
one mounting hole at the rear top (9), and a drop-down link (8) at the rear
bottom. The TLX43-FLB ybar is supplied with two drop down links that t in
two locations (1) on top of the subwoofer. These mounting points allow the
subwoofer to be connected to the TLX43-FLB ybar in various congurations,
or joined to another TLX212L.
1. Location for Top Mounting Links – TLX43-FLB ybar is supplied with
two drop down links that t in these two locations. The bottom links (6) of a
second TLX212L subwoofer can also t here.
2. Top Pins – Secures the mounting links of the TLX43-FLB ybar (if used) or
the drop down links of a second TLX212L subwoofer.
3. Slot – TLX43-FLB ybar is supplied with two drop down links, and two bolts
that t into these slots.
4. Bottom Bolts – These allow the bottom mounting links (6) to be
positioned up or down, by sliding in the slot, then securing with the bottom
pin (5).
5. Bottom Pins – Secures the bottom mounting link (6) in the down or
up position.
6. Bottom Mounting Links – These connect to the top of a second TLX212L
subwoofer or the mounting lugs of a TLX43-FLB ybar that can be tted
below the subwoofer. Fitting the ybar beneath the subwoofer allows an
array of up to 4 TLX43 cabinets to be hung below the subwoofer.
7. Rear Pin – This is used to connect the drop down link (8) to a subwoofer
below, or to the rear mounting hole of a TLX43-FLB ybar attached beneath
the subwoofer.
8. Rear Drop-Down Link – This is used to connect to the rear mounting hole
(9) of a second TLX212L subwoofer, or to connect to the rear mounting hole
of a TLX43-FLB ybar attached beneath the subwoofer.
9. Rear Mounting Hole – This is used to connect to the drop-down
link (8) of a TLX212L subwoofer above it, or to the drop-down link of a
TLX43-FLB ybar.
9
1
3
1
6
8 7
4
5
2