Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
- Chapter 4: Assembling one TLX212L Subwoofer on a TLX43-FLB Flybar
- Chapter 5: Assembling a TLX43 Array with a TLX212L Subwoofer
- Chapter 6: Groundstack of two TLX212L Subwoofers
- Chapter 7: Groundstack TLX212L Subwoofer and TLX43 Array
- Chapter 8: Safety Inspection
- Chapter 9: Enclosure Quantities and Combinations for TLX43-FLB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
14 TLX43 and TLX212L Rigging Manual
2.10.1 Rigging Pin Installation
Pin Installation
The following example shows how to use a pin to join the lugs of a TLX43
cabinet and a TLX43-FLB ybar. Exact details of the connections for various
congurations are given in the various chapters of this manual.
1. Support the weight of the components to be joined.
2. Align the top lug of the TLX43 cabinet with the bottom lug of the TLX43-
FLB ybar. Align the lug holes so the pin can pass through and join
them together.
3. Press the button (2) at the end of the pin, and insert the pin in as far as
it will go. The spring balls(1) will retract while the button is being held,
allowing the pin to pass through the holes.
4. Release the button (2) when the pin is fully inserted.
5. Check the pin is correctly inserted as far as it will go, and that the spring balls
are visible. Check that the components being connected have been correctly
captured together by the pin.
6. With the weight of the components still supported, and without pressing
the button (2), try to pull on the pin sharply, to check it is secured in position
by the spring ball locking mechanism.
Pin Removal
1. Support the weight of the components to be disconnected.
2. Press the button (2) and pull out the pins joining the components together.
3. Carefully separate the components.
1
2
Not inserted fully and
spring balls are not visible