Manual

TLX43 and TLX212L Rigging Manual 21
Chapter 3: Assembling a TLX43 Array on a TLX43-FLB Flybar
3.0.1 Required Components
Item Quantity
TLX43-FLB Flybar 1
TLX43 Cabinet 10 (maximum)
3.0.2 Preparation
Use the EASE FOCUS II software application to design your system to suit the
venue. This will calculate which ybar mounting hole to attach your bow shackle,
and at which angle to set each TLX43 cabinet to achieve optimum coverage.
3.0.3 Location
Move the rst TLX43 cabinet so it is sitting upright on a safe at surface,
directly below the suspension point.
3.0.4 Measured Weights
Item Quantity Total Weight including one TLX43-FLB Flybar
TLX43 1 14.8 kg 32.6 lbs
2 22.8 kg 50.3 lbs
3 30.8 kg 67.9 lbs
4 38.8 kg 85.5 lbs
5 46.8 kg 103 lbs
6 54.8 kg 121 lbs
7 62.8 kg 138 lbs
8 70.8 kg 156 lbs
9 78.8 kg 174 lbs
10 86.8 kg 191 lbs
TLX43-FLB Flybar Working Load Limit (WLL)
Item Working Load Limit (WLL)
TLX43-FLB 94 kg 207.23 lbs
The following procedure shows how to build an array of TLX43 cabinets by
adding them one at a time.
Alternatively, cabinets can be pre-assembled into groups of four, and then
connected to the ybar at a later time. This method is shown in procedure 3.2.
The system is suspended using a TLX43-FLB ybar that attaches to your
lifting system.
The top TLX43 cabinet connects to two front lugs on the ybar, and one rear
drop-down link.
Four rear mounting holes on the back of the TLX43 allow the cabinet angle to
be selected from 0, 2.5, 5.0, or 7.5 degrees. To set the site angle of the top TLX43
element parallel to the TLX43-FLB, select the 0 degree hole to attach the top
TLX43 enclosure to the ybar.
 WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 10 TLX43 CABINETS FOR ONE TLX43-FLB
FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT INJURY
OR DEATH.
3.0.5 Personnel
The following procedures shall be undertaken by experienced, certied,
qualied, and authorised personnel only. The procedures require the use of three
or more authorised persons.
Protective Headwear shall be worn
Protective Footwear shall be worn
Protective Gloves shall be worn
Protective Eyewear shall be worn
Practice Safe Lifting