Manual
Table Of Contents
- 1. Important Safety Instructions (Amplifiers)
- 2. Welcome
- 3. The Flashline System
- 4. Connecting the Loudspeakers
- 5. System Configurations
- 6. AMPLIFIER RACK ROUTING
- 7. Rigging the Flashline system
- 8. The 20000DP AMPLIFIER
- 9. Amplifier Installation
- 10. Product Overview
- 11. Signal Flow and Lake Processing
- 12. Lake Controller Software
- 13. Warranty and Support
- 14. Maintenance
- 15. Technical Specifications
user manual
Flashline
Flashline User Manual
page 50
14. Maintenance
14.1 Removal of the drive units
Remove the screws securing the top and bottom butterfly plates. Remove the screws securing the mid/high section
and carefully lift out and away from the cabinet. Disconnect all cables and make a note of the polarity and location
for later reconnection. The high frequency compression drivers, high-mid drivers and low-mid drivers can now all
be accessed for servicing.
Remove the screws holding the rear driver doors in place and remove the access doors. The low frequency drivers
can now be accessed for servicing.