Manual
Table Of Contents
- 1. Important Safety Instructions (Amplifiers)
- 2. Welcome
- 3. The Flashline System
- 4. Connecting the Loudspeakers
- 5. System Configurations
- 6. AMPLIFIER RACK ROUTING
- 7. Rigging the Flashline system
- 8. The 20000DP AMPLIFIER
- 9. Amplifier Installation
- 10. Product Overview
- 11. Signal Flow and Lake Processing
- 12. Lake Controller Software
- 13. Warranty and Support
- 14. Maintenance
- 15. Technical Specifications
user manual
Flashline
Flashline User Manual
page 16
5.2 Suggested amplifier loading for subwoofers
Each amplifier powers up to six TFS-900B or TFS-900L enclosures. Each NL4 connector can power three
subwoofers. Each subwoofer has a drive unit wired to each pair of pins on the NL4 connectors.
Do not use the NL4 and NL8 connections
simultaneously on one amplifier.
In this configuration speaker cable lengths should not be greater than 20m due to damping factor considerations.
Each amplifier is connected to one of the three
phases on the power supply. For optimum loading on
large systems it is good practice to load all phases
equally.