Quick Start Guide

Quickstart Guide
TCS series
TCS Series Quickstart Guide - Page - 3
Mounting and Fixing
The table below summarises the rigging parts or kits required for various applications, and some examples of the possible rigging
options are illustrated.
CS series cabinets are designed with multiple internal rigging points to suit many possible mounting methods in permanent
installations. All cabinets can be simply suspended using optional M8 or M10 shoulder eyebolts coupled to the internal rigging
points provided. Remove the appropriate countersunk screws and replace them with eyebolts, which must have a thread length of
at least 18mm. Use the rear rigging point to angle the cabinet for optimum room coverage. Cabinets may be hung upside down if
required. Turbosound WB-20, WB-55 and CB-55 wall and ceiling brackets are optionally available for TCS series cabinets, and
these are also compatible with OmniMount wall and ceiling brackets which use 60mm x 60mm hole spacing.
Model
Wall
Ceiling
Downfill
Vertical
Array
Horizontal
Array
Eyebolts
TCS-61
WB-20
CB-55
SB-61
ICC-61
EB-8
TCS-122
WB-55
CB-55
FP-1
ICC-2V
ICC-2H
ICC-6H
FP-1
ICC-2H
EB-10/18
TCS-152
WB-55
CB-55
FP-1
ICC-2V
ICC-3H
ICC-5H
FP-1
ICC-2H
EB-10/18
TCS-1561
ICC-2V
EB-10/18
TCS-B15A
FP-2
ICC-4H
EB-10/18
TCS-B15B
FP-2
ICC-4H
EB-10/18
TCS-B218
EB-10/18
Some typical examples of the possible rigging options are shown here: