User's Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling an MV212 Array on a MAN-FG Fly Grid
- Chapter 4: Assembling MS215 Subwoofers on a MAN-FG Fly Grid
- Chapter 5: Assembling an MV212 Array with a MS215 Subwoofer
- Chapter 6: Groundstack of two MS215 Subwoofers
- Chapter 7: Groundstack MS215 Subwoofer and MV212 Array
- Chapter 8: MV212-VT and MS215-VT Vertical Transporters
- Chapter 9: Safety Inspection
- Chapter 10: Enclosure quantities and combinations for MAN-FG fly grid suspension at 10:1, 7:1, and 5:1 design factors
44 MANCHESTER SERIES Rigging Manual
6
7
4
8
1
1
9
12
11
10
10
5. Prepare the rst MV212 cabinet, by pulling out the front lower rigging pins
(6), and the rear lower rigging pin (7).
6. Carefully lift the MV212 cabinet until its lower front mounting slots t over
the 2 front links (1) of the MAN-FG y grid. Reinsert the front pins (6) to
secure the MAN-FG y grid links (1) to the MV212.
Take care not to trap your ngers between components.
7. Align the MV212 cabinet's rear lower mounting hole with the top hole (8) in
the ground stack plate (4). Reinsert the rear pin (7) to secure the rear of the
MV212 to the ground stack plate.
Double check that all pins are correctly inserted,
before proceeding further.
8. Prepare the lower MV212 for the next MV212 cabinet, by pulling out the 2
front upper rigging pins (9). The spring-loaded top links (10) will move to the
up position. Reinsert the pins (9) to secure the links in the up position.
9. Pull out the rear upper rigging pin (12), and slide the MV212's rear mounting
plate (11) upwards and reinsert the rigging pin (12) into one of the available
holes. Each hole is marked with an angle; choose the hole which matches
the angle you want to set the next MV212.