User's Manual

43 MANCHESTER SERIES Rigging Manual
1
2
3
2
1
4
5
Ground Stack Plate
For angle holes marked
-6 , -3 , 0 , 3 , and 6 , secure
the Ground Stack Plate
with a rigging pin in hole 12
of the MAN-FG Spine
For angle 1
use hole 11
For angle -1
use hole 13
Procedure 7.1 - Attaching the MAN-FG y grid to the MS215 Subwoofer stack
1. Perform the previous procedures in Chapter 4 to attach the MAN-FG y grid
to the MS215 subwoofer(s).
Procedure Description of Work Check
4.1 Attaching the MS215 Subwoofer to the
MAN-FG y grid
Double check all pins are correctly inserted, and that the
MAN-FG y grid is securely attached.
2. Pull out the upper rigging pins (2) in the MAN-FG y grid and move the links
(1) in the up position. Reinsert the pins (2) to secure the links (1) in the up
position. The rear top mounting links (1) in the up position can be used as
tie-down points.
3. Remove the Single Pick Point (3) and attach it to its stowage postion in the
MAN-FG y grid, using its own rigging pins.
4. Pull out the ground stack plate (4) and attach it to the center spine of the
MAN-FG y grid, using one of the attached rigging pins (5). The plate holes
are marked with the angles from -6 to +6 degrees. Choose the angle that
you want to set the rst MV212 cabinet from horizontal.
For holes marked 6, 3, 0, -3, and -6 degrees, use Hole 12 on the center spine.
For the hole marked 1 degree, use Hole 11.
For the hole marked -1 degree, use Hole 13.