How to Guide

TurboLock TL - 99 9
Part 2 - Installing the Strike
In most cases, the existing strike plate and setup can be used. If you wish to use the one included with your lock, skip to Section
4.1, Part 3.
3.2 Main Installation
Step 1. Start with the Outside Knob. Feed the cable
through the square hole in the latch and thread
the two pegs through the smaller, round holes.
If needed, have someone hold the door itself or
hold the Outside Knob at against the front of the
door afterwards. (Fig. 4 and Fig. 4a)
Do NOT force the cable’s connector end through
any part of the lock. Damaging the connector may
make the lock unusable.
It’s highly recommended to leave the door open during installation.
(Fig. 4)
(Fig. 4a)
(Fig. 1)
(Fig. 2)
(Fig. 3)