How to Guide

14 TurboLock TL - 99
Step8. Position the strike and strike box, then use a pencil to mark the center points
of the screw openings in the strike plate. Set the strike and strike box aside
and drill two small holes at each center point.
Step9. Position the strike and strike box. Add the two remaining Wood Screws and
use a screwdriver (not included) to secure them.
4.2 Main Installation
Step 1. Start with the Outside Knob. Feed the cable
through the square hole in the latch and thread
the two pegs through the smaller, round holes.
If needed, have someone hold the door itself or
hold the Outside Knob at against the front of the
door afterwards. (Fig. 13 and Fig. 13a)
Do NOT force the cable’s connector end through
any part of the lock. Damaging the connector may make the lock unusable.
It’s highly recommended to leave the door open during installation.
(Fig. 13)
(Fig. 13a)