User's Manual

Model : IA-300
Installation Guide
Page 5
16. Enter the User Name and Password supplied by the Internet service provider. Click
Connect.
17. The message Logging on to network confirms a valid user name, password, and
VPN IP address. Please wait for the Connection Established window before
proceeding.
Note: If logon domain is required, enter username, password and logon domain
supplied by your ISP.
18. The PPPoA service connection is now established. Click Close and the PPPoA icon
appears on the task bar
NOTE: The default installation ADSL mode is ANSI T1.413 Issue 2 or ANSI. If your ISP
is providing a different mode then you need to change the setting
19. On the right-hand side of the task bar, right click on the Diagnostic Tools icon. Then
select Configuration.
20. The Configuration window appears. Select the ADSL Mode option and then select
the ADSL mode type provided by your ISP. The service mode type will be one of the
following:
q
ITU G.992.1 Annex A (G.dmt) ....................referred to as G.dmt
q
ITU G.992.2 Annex A/B (G.lite)..................referred to as G.lite
q
ANSI T1.413 Issue 2.......................................referred to as ANSI
21. After you select and check your ISP’s service mode, click Set.
Congratulations, you are done. Your IA-300 ADSL card the Internet is established!