User's Manual

Model : IA-300
Installation Guide
Page 3
POINT TO POINT SERVICE FOR WINDOWS 95B
1. After installing the IA-300 card, power-up the PC system. The Hardware wizard will
detect the IA-300 as a PCI Network Controller, click Next.
2. Insert the CD labeled IA-300 Driver into your CD-ROM drive. Then click Other
Locations.
NOTE: If the driver is not detected, click Back, insert the IA-300 Driver CD, then click
NEXT.
3. When the Select Other Location window appears, enter <CD drive
letter>:\Driver\PPPoA9x (e.g. D:\Driver\PPPoA9x) and click OK.
4.
The Update Device Driver Wizard window appears. Click Finish. The Insert Disk
window appears. Click OK.
5. The Copying Files window appears. Enter <CD drive letter> :\Driver\PPPoA9x (e.g.
D:\Driver\PPPoA9x) and click OK.
6. When the Service Option window appears, click Next for the default installation
(VPI=0, VCI=35, Framing=VC MUX). For Advanced settings, please consult your
ADSL service provider for detailed information.
NOTE: If you clicked Advanced, the Service Options window shows the Connection
Address. Enter the service Connection Address, click OK. The previous Service
Option window will appear, click Next.
NOTE: During the installation process you may be asked to insert your Windows 95
CD. Insert the Windows 95 CD into the CD drive and click OK.
7. The Copying Files window will now appear. Enter <CD driver letter>:\WIN95 (e.g.
D:\WIN95) and click OK.
8. At the conclusion of the IA-300 driver installation, the Diagnostic Tool icon is active and
monitoring connectivity. Diagnostic Tool with blinking or solid Black or Green lights
indicates a good connection. Diagnostic Tool with Red lights indicates a connection
error or driver load error. Verify that the cable is properly connected to the data port of
the service and IA-300 card.
9. You must now make a network connection, go to page 8.