User's Manual

Model : IA-300

Installation Guide

Page 2

POINT TO POINT SERVICE FOR WINDOWS 95A

1. After installing the IA-300 card, power on the PC system. The Hardware Wizard will

detect the card as a PCI Network Controller. Select the Driver from disk provided by

hardware manufacturer option. Click OK.

Insert the IA-300 Driver CD into the CD-ROM drive.

3. The Install From Disk window appears. Enter the <CD drive letter>:\Drivers\

Win95_98\ PPPoA (e.g. D:\Drivers\Win95_98\PPPoA), then click OK.

4. When the Service Option window appears, click Next for the default installation

(VPI=0, VCI=35, Framing=VC MUX). For Advanced settings, please consult your

ADSL service provider for detailed information.

NOTE: If you clicked Advanced, the Service Options window shows the Connection

Address. Enter the service Connection Address, click OK. The previous Service

Option window will appear, click Next.

NOTE: During the installation process you may be asked to insert your Windows 95

CD. Insert the Windows 95 CD into the CD drive and click OK.

NOTE: If during the file copying process a file is reported as “not found” enter the path

<CD Drive letter> :\Win95 (e.g. D:\Win95)

5. At the conclusion of the IA-300 driver installation, the Diagnostic Tools icon is active

and monitoring connectivity. The Diagnostic Tools – found on the task bar – with

blinking (or solid) Black or Green lights indicates a good connection. Diagnostic

Tools with Red lights indicate a connection error or driver load error. Verify that the

cable is properly connected to the data port of the service and the IA-300 card.

6. You must now make a network connection, go to page 8.