User's Manual

Model : IA-300

Installation Guide

Page 8

PPPoA ADSL NETWORK CONNECTION

NOTE: This section is for Win95A, 95B and 98 users only.

1. Double click the My Computer icon on the desktop. Then double click the Dial-Up

Networking icon. The Dial-Up Networking window will appear.

NOTE: Another dialog window may prompt for the entry of the Area Code if this is a

first time Network connection. Enter the Area code and click OK.

2. Double-click on the Make New Connection icon.

3. Enter the connection name (e.g. My Connection) and set the connection device to

ITeX ADSL PCI NIC.

NOTE: use the scroll down menu to locate the ITeX ADSL PCI NIC; then click Next.

4. Enter the Host Name or IP Address, if provided by your ISP, otherwise enter (0) zero,

and then click Finish.

5. The new connection will appear in the Dial-Up Networking window. Double-click the

My Connection icon to begin a Dial-Up session.

6. Enter the User Name and Password supplied by the Internet service provider. Then

click Connect.

NOTE: The Virtual Private Network server name (or IP address) has been previously

entered.

7. The Connection window reports the status of a connection. The message Logging on to

network confirms a valid connection.

NOTE: If logon domain is required, enter username, password and logon domain

supplied by your ISP.

8. The PPPoA service connection is now established. Click Close and the PPPoA icon is

transferred to the task bar.

NOTE: The default installation ADSL mode is ANSI T1.413 Issue 2 or ANSI. If your ISP

is providing a different mode then you need to change the setting

9. On the right-hand side of the task bar, right click on the Diagnostic Tools icon. Then

select Configuration.

10. The Configuration window appears. Select the ADSL Mode option and then select

the ADSL mode type provided by your ISP. The service mode type will be one of the

following:

ITU G.992.1 Annex A (G.dmt) ....................referred to as G.dmt

ITU G.992.2 Annex A/B (G.lite)..................referred to as G.lite

ANSI T1.413 Issue 2.......................................referred to as ANSI

11. After you select and check your ISP’s service mode, click Set.

Congratulations, you are done. Your IA-300 ADSL card the Internet is established!