Electric Oven Service Manual

APPENDIX A - REPLACING OVEN COMPONENTS
A-15
Item Part Number Hardware Description Hardware Part
Number(s)
Air Pressure Switch 102836 Screw, #8 x 3/4, PPHD, Plt-Stl 104178 (x2)
Bracket, Thermostat HHC-6390 Screw, #8 x 3/8, Sht Mtl, PPHD, Type A, SS 101696 (x2)
Burner Assembly HHC-6468 Nut, #10-32, Serrated Hex Flange, SS 100903 (x4)
Clamp, Conduit, 1/2 Nominal, Zinc 103632 None N/A
Combustion Motor (90-degree) 103620 Included Included
Combustion Motor (Inline) - not pictured 103656 Included Included
Flame Sensor 103624 None N/A
Flame Sensor Wire 103575 None N/A
Flame Spreader See Burner Assembly Included Included
Gas Valve, Modulating 102832 None N/A
Ignition Module 103626 Screw, 8-32 x 1/2”, PPH, SS
Standoff, 1/4 Hex, M/F, 8-32 x .50 Lg, Al
101630 (x4)
101946 (x4)
Pipe and Valve Assembly HHC-6513 Standoff, 5/8 Round, .25 Thru x .75 Lg, Al
Clamp, Conduit, 1.00
Screw, #10-32 x 1.5 Lg, SS
101909 (x2)
100133 (x2)
101480 (x2)
Relay, K4, Sealed, 24 VAC, 20A 101275 Screw, 6-32 x 3/8, Sht Mtl Drill Point, PPHD, Zinc 101684 (x2)
Shield, Gas Pipe HHC-6613 Screw, #8 x 3/8, Sht Mtl, PPHD, Type A, SS 101696 (x2)
Shutter, Inlet Air Blower HHC-6617 None N/A
Spark Assembly 103623 None N/A
Spark Assembly Wire 103574 None N/A
Thermostat, High Limit 102075 Screw, 6-32 x 1/4 Lg, PPHD, SS 101565 (x2)
Tube, Flexible, Gas, 1/2-Inch 103628 None N/A
Tube, Flexible, Gas, with LP Orifice 103633 None N/A
Wire Harness, LOV, Air Switch, 25V HHC-6599-3 None N/A
Wire Harness, LOV, High Limit, 25V HHC-6599-6 None N/A
Wire Harness, LOV, K4 Ground HHC-6599-4 None N/A
Item Part Number Hardware Description Hardware Part
Number(s)
Wire Harness, HV, Main HHC-6598-1 None N/A
Wire Harness, LOV, Main HHC-6599-1 None N/A
Replacing Items - Multiple Panel Removal Required
WARNING: Before removing or replacing any oven component, thoroughly read the safety
instructions found at the front of this manual and Oven Systems (pages 21-28). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in
serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from
the wire harness (where applicable).