Electric Oven Service Manual

A-8 APPENDIX A - REPLACING OVEN COMPONENTS
Blower Motor *
Blower Motor Controller
Bracket, Gear Drive Controller (2 if split belt)
Gear Drive Controller (2 if split belt)
Wire Harness, Conveyor Drive AC
EMI Filter
Bracket, EMI Filter
Display
Cable, Display, Power, 2-Pin
Cable, Display, Ribbon
Smart Card Reader
Cable, Smart Card Reader
Control Board
Gear Drive (2 if split belt) **
Wire Harness, LOV, Signal, Gear Drive
Cord, Power, 12/3, SOOW, NEMA L620
RTD Probe
Fuses
Fuse Block
Power Supply
Relay, K3, 24 VDC, 20A
Speaker
Transformer, Burner
Wire Harness, K3 Relay and Transformer
Replacing Items - Right End Bell
WARNING: Before removing or replacing any oven component, thoroughly read the safety
instructions found at the front of this manual and Oven Systems (pages 21-28). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in
serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from
the wire harness (where applicable).
**NOTE: For blower motor detail, see page A-12.
**NOTE: For gear drive detail, see page A-10.