Electric Oven Service Manual

15
The Config Mode
The CONFIG MODE (Figure 9) serves four main
purposes:
1. To access the smart card screen.
2. To access the fault count screen.
3. To access the
SETUP MODE.
4. To access the
TEST MODE.
To access the CONFIG MODE, press the up key
from the
OVEN OFF MODE.
Smart Card Screen
The smart card screen allows the user to
-Load a menu from smart card to oven.
-Save a menu from oven to smart card.
To load or save a menu,
1. Press L3 (Figure 9) to access the smart card
screen (Figure 10).
2. Insert a smart card into the smart card slot
(Figures 11 and 12), with the gold chip
facing the inside of the oven.
3. Load or save a menu.
- Press R1 to load a menu from the smart
card to the oven (Figure 10).
- Press R2 to save a menu from the oven to
the smart card (Figure 10).
Updating the Firmware
From the oven off screen,
1. Insert the gray smart card (see Figure 11)
with the gold chip facing the inside of the
oven. If multiple smart cards are required,
they will be labeled in sequence - ensure the
correct sequence is followed.
2. From the
COOLING DOWN or OVEN OFF
MODE
, press and hold the idle key until the
oven resets (approximately 5 seconds). The
display will go blank until the upload is
complete.
3. When the oven beeps one long high tone,
the load was successful. If a second card
was provided, insert it.
4. When the oven restarts and the display
turns on, the update is complete. Remove
the smart card.
NOTE: If the update is unsuccessful, the
display will remain off and the oven will beep
one long, low tone. If this occurs, repeat the
above procedure. If the update fails multiple
times, a smart card may be damaged. Contact
TurboChef to obtain a new smart card.
INSERT SMART CARD
PRESS [BACK] TO EXIT
OVEN MODES
Figure 11 Smart Card slot location
SMARTCARD
FAULTS
CONFIG MENU
SETUP
TEST MODE
Figure 9: Config Mode
LOAD FROM CARD
SMARTCARD
SAVE TO CARD
Figure 10: Smart Card Screen
Figure 12: Insert Smart Card Screen
L1
L2
L3
R1
R2
R3
L1
L2
L3
R1
R2
R3
L1
L2
L3
R1
R2
R3