Use and Care
1. Plug in and turn on the power and lamp switch located on the top of the bottom grille
right side.
The display panel will light up and make a beeping noise.The compressor will begin
to run.
2. The default temperature setting is No. “16˚F” for the TGIM-23*.
The default temperature setting is No. “16˚F” for the TGIM-49*.
3. The compressor is automatically cycled by the electronic controller (PCB, F-Sensor).
4. The defrost cycle is automatically controlled by the D-sensor, and the PCB.
5. Push the temperature up(+) button for higher temperatures and the temperature
down(-) button for lower temperatures.
6. Evaporator fan motor will run after all doors are completely closed.
7. Good air flow in freezer is critical.
Be careful when stationing the product so that it does not press against the back
wall,and is at least 4 inches away from the evaporator compartment.
5
Turbo air
BASIC OPERATION