User's Manual

TuneUp Utilities 201 4 © 20 13 C opyright A V G Tec hnologies C Z, s.r.o. A ll rights res erved. 35
Required by system
The services of the program that run continuously in the background have been turned off.
Impactless
The program cannot be disabled because it does not have a negative impact on the system load.
Status description
To the right of the Current status column, the Status description column contains further information about
the current status of the program in question.
How to Disable Programs
Launch the TuneUp Program Deactivator module by going to the Optimize category in the Start Center
and selecting Disable programs under Reduce system load.
Alternatively, you can start the module by going to All functions in the Start Center and selecting the Disable
entry under Installed programs.
The TuneUp Program Deactivator module uses TuneUp Programs-on-Demand Technology, which reduces
the load on your system and therefore increases system performance.
How to Disable Programs
1. Select a program in the list that has the status Enabled.
2. Disable the program using the switch in the status column or in the details area or click on the
Disable button in the toolbar.
How to Enable Programs
1. Select a program in the list that has the status Disabled.
2. Enable the program using the switch in the status column or in the details area or click on the
Enable button in the toolbar.
How to Enable or Disable More than One Program
If you select more than one program at the same time, the possible action depends on the predominant
status. For example, if two selected programs are disabled and one is enabled, you can only enable the
programs. However, with two enabled and one disabled program, you can only disable the programs.
Following the action, a window is shown in the display area to the left informing you of the result of your
action.