Owner’s guide: IBC4024 ATTENTION! - 24 VOLTS Install using Tundra CM Series installation kit Ask your retailer ! www.tundrainternational.
Table of contents 1 Features ..................................................................................................................................................................... 3 1.1. Integrated Charge Controller ........................................................................................................................ 3 1.2. GFCI Protection .....................................................................................................................................
1 Features 1.1. Integrated Charge Controller The IBC4024 Chargers have undergone tens of thousands of hours of strenuous engineering testing to insure years of trouble-free operation. They have been designed and tested to provide maintenance free operation. The IBC4024 is the intelligent way to recharge your batteries.
2 General Information’s The IBC4024’s are state-of-the-art electronic 120 VAC to 24 VDC Converter / Battery chargers and are UL and CUL (Canadian) listed. Their compact size and quiet operation gives greater flexibility in selecting the mounting location for either OEM aftermarket or installation. The IBC4024 battery chargers have a built-in Charge Controller module.
3 General Operation The IBC4024 Charger will supply "clean" nominal 27.2 VDC (Normal Mode) power from input voltages that range from 105-130 VAC. The IBC4024 chargers are primarily designed for use with batteries; however, the output of the IBC4024 is a regulated, filtered DC voltage that can power sensitive electronics without the need for batteries or other filtering. The full rated capacity is available for loads, battery charging or both.
5 Trouble shooting guide 1. LOOSEN THE SCREW ON THE POSITIVE TERMINAL AND DISCONNECT THE POSITIVE WIRE. READ THE CONVERTER OUTPUT VOLTAGE USING A DC VOLTMETER. IF THE VOLTAGE IS ABOVE 26 VOLTS, THE CONVERTER IS WORKING PROPERLY. 2. IF THE CONVERTER OUTPUT IS ZERO VOLTS, USE AN AC VOLTMETER TO CHECK FOR PROPER VOLTAGE AT THE 120 VAC INLET, WHERE THE CHARGER IS PLUGGED IN. THIS VOLTAGE SHOULD BE BETWEEN 105 AND 130 VOLTS. 3. CHECK THE FUSES LOCATED AT THE FRONT OF THE CONVERTER.
6 Input / Output Specifications Input Output Dimensions Weight 7 105-130 VAC / 60Hz 27.2 VDC 13 x 6.5 x 3.4 (in.) 7.8lbs 17.1A 40A Limited One year warranty Tundra International Inc. warrants its battery chargers against defects in workmanship and materials for a period of one (1) year from the date of first consumer purchase. This warranty is given only to the first end-use purchaser of the product.
