User manual

Smart
Button
6. DC Start
All Series are equipped with DC Start (Cold Start). To start the UPS when
AC utility power is not available, simply press the smart button for
minimum 1 second.
On the other hand,
place the UPS away
from the monitor at
least 20 cm to avoid
interference.
4. Connection
Plug the UPS into a 2-pole, 3-wire grounded receptacle. Then connect
one computer-related device into each of the power receptacles supplied
on the back of the UPS.
5. Turn On/Off
• Press the smart button for minimum 1 second
to turn the UPS unit on. •
Press the smart
button until the LED turn into red then remove
your finger to shut down the UPS unit.
3. Placement
Install the UPS unit in any protected environment that provides adequate
airflow around the unit, and is free from excessive dust, corrosive fumes
and conductive contaminants. Do not operate your UPS in an environ-
ment where the ambient temperature or humidity is high.
D
O
N
’
T
C
O
N
N
E
C
T
A
L
A
Z
E
R
P
R
I
N
T
E
R
T
O
T
H
E
U
P
S
U
N
I
T
T
H
I
S
M
A
Y
C
A
U
S
E
T
H
E
D
A
M
A
G
E
O
F
T
H
E
U
N
I
T