Installation Guide
24” Max
24” Max
Rise
Run
Rise
Run
= 1:12 min
TUFTEX® Mul-Wall
6mm 48”x96” Installaon Instrucons
Preparing for Your Project
Rise
Run
Run
Rise
= 1:12 MIN
Max
24”
Spacing : 24” OC Max
Slope: 1:12 (5 °)
Open channels
(flutes) in panel must
run vertically when
applied outside.
Ensure your structure has the
appropriate spacing and slope
to support TUFTEX® Multi-Wall
panels and allow for proper
drainage.
Tools Required
Estimating Material
TAPE
MEASURE
DRILL
9/32” DRILL BIT
1/4” HEX DRIVER
CIRCULAR SAW
(80+TOOTH BLADE)
PLASTIC CUTTING BLADE
MARKER
EYE PROTECTION
C-CLAMPS
JIG-SAW
(OPTIONAL)
TUFTEX® MULTI-WALL PANEL
Length: 96”
Width: 48”
Coverage: 32 sq
* Install with flutes vertically if
applying outside
TUFTEX® 2” FASTENERS
Head: 1/4” Hex
Estimate: 16 fasteners/panel
* Predrill panels
* Do not fasten on profiles
TUFTEX® U-CHANNEL PROFILE
Seals top and bottom of panels
Length: 96”
Estimate: Ridge + Eave length in
feet divided by 8 = pcs needed
TUFTEX® H-CHANNEL PROFILE
Joins two panels side by side
Length: 96”
Estimate: Joint length divided
by 8 = pcs needed
TUFTEX® ANTI-DUST TAPE
Length: 32 feet
Solid - apply to top of panel
Vented - apply to bottom of panel
* Each roll has both vented and
solid tape
Storing Panels
S pide U
Keep panels protected from direct sun-
light and moisture when stored.
When working on project, be sure sheets
are positioned with UV film side upwards.
UV Film
Solid Tape
Applied between U Channel
and panel width side
(Top Only)
Vented Tape
Applied between U Channel
and panel width side
(Bottom Only)
TUFTEX® 2” Fasteners
Fasten panels to
structure
U-Channel
Applied over solid tape
on panel width side
U-Channel
Applied over solid tape
on panel width side
H-Channel
Connects panels along
length side
100% SILICONE
SEALANT
(OPTIONAL)
Always refer to local building code before starting any project
* Panels have polyethylene film applied to both sides to prevent scratches. One side is marked as UV protected and should face outward.
DO NOT fully remove these films until project is complete.
TUFTEX® UNIVERSAL RIDGE
Length: 51”
Width: 18”
Coverage: 4 Linear feet
For use on roofing application