Owner manual

Page - 1 - of 3 - 1/28/2008 – Rev122006

INSTALLATION INSTRUCTIONS

TUFFY CENTER SECURITY CONSOLE #’s 012, 013, 016, 017,

023, 024, 032, 033

Call (970) 564-1762 for Technical Support

Please read and fill out the enclosed warranty registration card to activate your warranty.

PARTS CHECKLIST

(9)3/16” Washers (6)5/16” Washers (5)10-32 Nuts (4)10-32 Acorn Nuts

(3)5/16” Nuts (2)1/4” Hole Plugs (8)10-32x1/2” Bolts

(1) 5x16x1-3/4” Bolt Rubber Seal

(2) 5/16x5-1/2” Bolts

(2)Seat Belt Straps

PAGE 1
INSTALLATION INSTRUCTIONS TUFFY CENTER SECURITY CONSOLE #’s 012, 013, 016, 017, 023, 024, 032, 033 Call (970) 564-1762 for Technical Support Please read and fill out the enclosed warranty registration card to activate your warranty.
PAGE 2
TOOLS NEEDED • • • • • • • • • Electric drill 3/8” Drill bit Marker or pencil Knife ½” Socket and ratchet ½” Wrench 3/8” Wrench 5/16” Wrench Silicone sealant (Recommended) PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION. 1. Install the rubber seal around the edge of the lid and check the lock operation (See Figure 1) 2.
PAGE 3
10. Fasten down the rear of the console through Holes #4 & #5 using (2) 5/16”x 5-1/2” Bolts, (2) 5/16” Locknuts, and (4) 5/16” Washers. Fasten down the front of the console through Hole #3 using (1) 5/16” x 1-3/4” Bolts, (1) 5/16” Locknut, and (2) 5/16” Washers. 11. Using (4)10-32x1/2” Bolts, (4) 3/16” Washers, and (4) 10-32 Nuts attach the seat belt support straps by placing the seat belt between the support strap and the console. (See Figure 4) Make sure to put the washer on the outside of the strap. 12.