Use And Care Manual

Roadside Warning LED Lamp

Please note:

1. Do not replace the LED components.

2. Do not rework or disassemble this product.

3. Do not expose the LED glare directly to the eyes of people or animals. If you

continue to observe the light for 10 seconds, you may lose sight or blindness.

Specifications:

1. Material: ABS Plastic

2. Weight: 415g (not including the battery)

3. Packing Dimensions: 9.1*2.2*8.3 inches

5. Luminance: Maximum 1000 lumens

Instruction

[ Turn ON/OFF ]

Press the switch on the back of the lamp for 3

seconds to turn it on or off.

[ Change Light Mode ]

Press the switch to select among 4 modes while

the light is on.

[Light Modes]

• High Bright

• Low Bright

• Red Light

• Red Light Flashing

[Battery Installation]

Open the cover of the battery compartment on the

back to install the batteries. This lamp works with 4x

AA batteries (included) or 2 x 18650 batteries (not

Included) .

PAGE 1
Roadside Warning LED Lamp Please note: 1. Do not replace the LED components. 2. Do not rework or disassemble this product. 3. Do not expose the LED glare directly to the eyes of people or animals. If you continue to observe the light for 10 seconds, you may lose sight or blindness. Specifications: 1. Material: ABS Plastic 2. Weight: 415g (not including the battery) 3. Packing Dimensions: 9.1*2.2*8.3 inches 5.
PAGE 2
[ Charging your device from this lamp ] Plug a phone charging cable (not included) to the USB charging port on the back. [ Charging the Lamp batteries] Plug the Micro-USB end of your phone charging cable (not included) onto the Micro port on the back. Input Voltage: 5V [ Stand Adjustment ] Adjust the handle on the back to your desired angle. It can be placed on the floor or hung on an object.